Fives InspectionWash Overview
The Fives InspectionWash is a front-loaded cabinet washer that cleans and dries parts selected for CMM inspection, with a rotating turntable, 6 bar aqueous spray and two turntable sizes for parts up to 700 x 700 x 1200 mm.
Key Specifications
Specification | Fives InspectionWash |
Manufacturer | Fives Group |
Model | InspectionWash |
Category | Automation equipment / Front-loaded industrial parts washer |
152 cm (60 in) | Max part size 700 x 700 x 1200 mm, Typical parts Transmissions, cylinder blocks and heads |
122 cm (48 in) | Max part size 550 x 550 x 800 mm, Typical parts Crankshafts, camshafts, small parts |
Price | Price on request |
Price available on request. Any price is indicative, not final and may change.
Applications
CMM Labs
Automotive Powertrain
Aerospace
Fives InspectionWash Review Summary
Before a part is measured on a coordinate measuring machine it must be clean, or chips and oil will distort the result. InspectionWash does this in one chamber: the part sits on a rotating turntable while fixed nozzles spray at up to 6 bar, then it is dried. Large swing-out doors and a slide-out table allow hand or crane loading. Two turntables take parts up to 550 x 550 x 800 mm or 700 x 700 x 1200 mm, enough for cylinder blocks and transmissions. It is a low-pressure flush, not a deburring machine.
Pros
Large part capacity
Single chamber
Crane loading
Simple
Cons
Low pressure only
Not for deburring
Who It Is For
It fits quality labs that inspect large machined parts.
Full review: Fives InspectionWash Review: Specs and Uses of the CMM Inspection Parts Washer
