Fives InspectionWash
The Fives InspectionWash is a front-loaded cabinet washer that cleans and dries parts selected for CMM inspection, with a rotating turntable, 6 bar aqueous spray and two turntable sizes for parts up to 700 x 700 x 1200 mm.
Before a part is measured on a coordinate measuring machine it must be clean, or chips and oil will distort the result. InspectionWash does this in one chamber: the part sits on a rotating turntable while fixed nozzles spray at up to 6 bar, then it is dried. Large swing-out doors and a slide-out table allow hand or crane loading. Two turntables take parts up to 550 x 550 x 800 mm or 700 x 700 x 1200 mm, enough for cylinder blocks and transmissions. It is a low-pressure flush, not a deburring machine.
Pricing is available on request. Any price is indicative only, is not final and may change; contact us for a confirmed quote.
Full review: Fives InspectionWash Review: Specs and Uses of the CMM Inspection Parts Washer
- 152 cm (60 in): Max part size 700 x 700 x 1200 mm, Typical parts Transmissions, cylinder blocks and heads
- 122 cm (48 in): Max part size 550 x 550 x 800 mm, Typical parts Crankshafts, camshafts, small parts
- Price: Price on request
